521704

Active holder with cig-plug
With USB-cable with cig-plug adapter. With tilt swivel.

The active holder charges your smartphone when it is in the holder. You can choose to connect the cig-plug to the car's 12 Volt socket, or to remove the cig-plug adapter and connect the USB cable to the car's (or stereo's) USB connector.

The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection. 12 Volt. Attach the holder onto a ProClip Mounting Platform in your car.

Important note!

In order to be able to transmit audio files from your device through the USB-cable, this feature must be supported by the stereo in your car. You can easily test if this works by connecting your device to the stereo with the USB/charging cable that comes with your device. Charging through USB works regardless.

INSTALLATION INSTRUCTIONS:
Please read all of the instructions and look at the pictures before attaching the holder.

1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.

2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.

3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.

4. The holder is in place.